Having this problem?

Voltage Auto Service specializes in advanced hybrid, plug-in hybrid and EV diagnostics. Schedule an appointment to have the fault properly tested before replacing parts.

2014 Ford Fusion SE Hybrid – Turn Signal Stuck On With B1D36:09

Aug 16
1 min read

CUSTOMER CONCERN

The right turn signal remains on whenever the ignition is on, while the left signal does not respond to the multifunction switch but does flash with the hazard switch; SCCM DTC B1D36:09 returns immediately.

CAUSE

SCCM switch data changed to OFF when the multifunction switch was removed, confirming an internal switch failure.

CORRECTION

Remove and replace the failed multifunction switch.

Recent Posts

See All

2020 Toyota RAV4 Hybrid LE – Hybrid System Fault With P0AA6-49 and P1C80-49

CUSTOMER CONCERN The hybrid system stores isolation-fault DTCs P0AA6-49 and P1C80-49 for the rear motor area. CAUSE Corrosion in the high-voltage floor under-wire harness caused the documented isolati

2021 Toyota Venza XLE – Park Assist Warning With U023A-87 After Collision Repair

CUSTOMER CONCERN After collision repairs and replacement of the front bumper and steering rack, the intuitive park-assist warning remains on and the EPS system stores U023A-87. CAUSE The replacement s

2020 Toyota Camry Hybrid SE – Check Engine Light With P2681-15

CUSTOMER CONCERN The engine control module stores DTC P2681-15 for the coolant-flow control circuit. CAUSE The confirmed repair identified a failed coolant flow control valve; Toyota's updated valve w

2014 Ford Fusion SE Hybrid – Turn Signal Stuck On With B1D36:09

CUSTOMER CONCERN

CAUSE

CORRECTION

Recent Posts

CALL US

EMAIL US

OPENING HOURS