Having this problem?

Voltage Auto Service specializes in advanced hybrid, plug-in hybrid and EV diagnostics. Schedule an appointment to have the fault properly tested before replacing parts.

2008 Toyota Camry Hybrid – Brake Pump Inoperative With C1364 C1365

Aug 15
1 min read

Updated: Aug 15

CUSTOMER CONCERN

Customer states the replacement brake actuator pump will not run or build pressure. DTCs C1246, C1364 and C1365 are stored, and accumulator pressure reads zero.

CAUSE

The hydraulic system had no accumulator pressure after actuator installation, preventing normal pump control until pressure was established and the service routine completed.

CORRECTION

Power brake-pump motor to establish accumulator pressure, perform complete ABS bleed and linear-valve relearn, clear brake DTCs...

Recent Posts

See All

2020 Toyota RAV4 Hybrid LE – Hybrid System Fault With P0AA6-49 and P1C80-49

CUSTOMER CONCERN The hybrid system stores isolation-fault DTCs P0AA6-49 and P1C80-49 for the rear motor area. CAUSE Corrosion in the high-voltage floor under-wire harness caused the documented isolati

2021 Toyota Venza XLE – Park Assist Warning With U023A-87 After Collision Repair

CUSTOMER CONCERN After collision repairs and replacement of the front bumper and steering rack, the intuitive park-assist warning remains on and the EPS system stores U023A-87. CAUSE The replacement s

2020 Toyota Camry Hybrid SE – Check Engine Light With P2681-15

CUSTOMER CONCERN The engine control module stores DTC P2681-15 for the coolant-flow control circuit. CAUSE The confirmed repair identified a failed coolant flow control valve; Toyota's updated valve w

2008 Toyota Camry Hybrid – Brake Pump Inoperative With C1364 C1365

CUSTOMER CONCERN

CAUSE

CORRECTION

Recent Posts

CALL US

EMAIL US

OPENING HOURS