Having this problem?

Voltage Auto Service specializes in advanced hybrid, plug-in hybrid and EV diagnostics. Schedule an appointment to have the fault properly tested before replacing parts.

2011 GMC Yukon Denali Hybrid – Brake-Control Codes After Programming

Aug 15
1 min read

CUSTOMER CONCERN

Brake and stability warnings remain after sequential module programming, and Electronic Brake Control Module DTCs C0561, C0299 and C12FF are stored.

CAUSE

Programming verification confirmed the required Electronic Brake Control Module learn procedures had not been completed.

CORRECTION

Perform the required Electronic Brake Control Module relearn procedures.

Recent Posts

See All

2020 Toyota RAV4 Hybrid LE – Hybrid System Fault With P0AA6-49 and P1C80-49

CUSTOMER CONCERN The hybrid system stores isolation-fault DTCs P0AA6-49 and P1C80-49 for the rear motor area. CAUSE Corrosion in the high-voltage floor under-wire harness caused the documented isolati

2021 Toyota Venza XLE – Park Assist Warning With U023A-87 After Collision Repair

CUSTOMER CONCERN After collision repairs and replacement of the front bumper and steering rack, the intuitive park-assist warning remains on and the EPS system stores U023A-87. CAUSE The replacement s

2020 Toyota Camry Hybrid SE – Check Engine Light With P2681-15

CUSTOMER CONCERN The engine control module stores DTC P2681-15 for the coolant-flow control circuit. CAUSE The confirmed repair identified a failed coolant flow control valve; Toyota's updated valve w

2011 GMC Yukon Denali Hybrid – Brake-Control Codes After Programming

CUSTOMER CONCERN

CAUSE

CORRECTION

Recent Posts

CALL US

EMAIL US

OPENING HOURS